Tenda W308R Setup Guide

8  PHYSICAL CONNECTION

4 Take an Ethernet cable to connect your modem with the blue WAN port of the router.

4 Then take another Ethernet cable to connect your computer with one of the Yellow LAN port of the router.

4 Please check the LED lights on the router after connection. Make sure SYS light is blinking, WLAN light is on or blinking, one of LAN ports(1,2,3,4) is on,           WAN light is on or blinking.

8 LOGIN TO THE MANAGEMENT PAGE OF THE ROUTER

4 Open your web browser, find the address bar and type in http://192.168.0.1

4 After successful login, you can see the following page and please choose your access method DHCP or PPPoE

4 Under Wireless, click Wireless Basic Settings to change the Primary SSID to your preffered name and save changes.

4 Click Wireless security settings to set an 8 characters  password settings for your Wi-Fi

4 Click on the tools settings and go to change the password, to change it from admin to your choice.

4 Click on your advanced settings to check connection status.

4 Finally click on the Remote Web Management and enable it.

    NOTE: This needs to be enabled only in case of trouble shooting and when asked by your Technical Support Officer.

    Please click below, For Video Guide :